![]() As a result, Microsoft has an incentive to develop an Arm-compatible version of Windows: Windows 11 for Arm (Microsoft started its efforts with an Arm-friendly Windows 10 OS, but that project was scrapped to focus on Windows 11). ARM got its start with mobile processors commonly used in smartphones and tablets. This gives the processors a big edge when it comes to efficiency and heat, but it also runs differently from x86-based processors (the architecture Intel and AMD processors use) that applications need to be heavily revised if they’re being translated from x86 to Arm.īut Apple Silicon isn’t the only Arm-based processor out there. (A restart is not required.) You now have blessed the Windows partition and the question mark should not appear on startup.These Macs use Apple Silicon processors, which run on Arm-based architecture. (Hint: Open image show below in a new windows for a better view.)Ĭlicking on this icon will open the Boot Camp Control Panel shown below.Ĭlick on the Windows folder icon (labeled here as BOOTCAMP) to highlight it.Ĭlose both windows. Once the Boot Camp drivers are installed, a Boot Camp icon will appear on the Windows Control Panel. Second, there is an alternative to entering the bless command from a OS X Terminal window. One should also make sure their iMac firmware is up to date by visiting the link "EFI and SMC firmware updates for Intel-based Macs". ![]() See the link "System requirements to install Windows on your Mac via Boot Camp". My Mac is a PC.įirst, for most iMacs, the Boot Camps drivers can be directly downloaded from the web. ![]() After removing the DVD, I did a few more reboots. The DVD was ignored and there was no question mark. This reboot resulted in a direct boot to Windows 7. Therefore, no part of OS X was ever installed.) (Actually, the installer never reached the point where it ask were to install. After doing so, I quit the Terminal application and canceled the OS X install. At this point, it occurred to me to enter the command bless -device /dev/disk0s1 -setBoot -legacy. The results confirmed the disk had only a MBR partition scheme with a single NTFS partition on /dev/disk0s1. I ran the commands distutil list /dev/disk0 and fdisk /dev/disk0. I proceeded to answer a few question and eventually reached the point were a could open a Terminal window. This time the Mac booted to the DVD and starting the OS X install process. ![]() The reboot proceeded with the DVD still in the optical drive. Upon successful completion, I was prompt for a reboot. I let setup proceed and the Boot Camp drivers installed. I inserted the DVD and Windows automatically asked to run Setup.exe. My guess is the firmware was looking for an OS X and when absent, settled for a Windows BIOS boot.įor this model, the Boot Camp drivers for Windows Vista are stored on the Apple OS X 10.6 Snow Leopard install DVD. Each time, a question mark momentarily appeared in the center of the screen, then the Mac booted to Windows 7. ![]() After installing, I removed the DVD and did a few reboots. The install proceeded normally, just like a PC. I deleted all partitions and created a single NTFS partition. I took an old iMac4,1 and booted from a Windows 7 SP1 32bit install DVD. If it worked for Fedora, I don't see why it wouldn't work for Windows. The machine was iMac7,1 (iMac 21 inch Mid 2007). I have never tried to do this, but I accidentally installed Fedora 21 workstation 32 bit mode this way from a live DVD. No OS X and therefore no Boot Camp Assistant. Can the internal drive be partitioned MBR? There would be no GPT partitions.Ĭan Windows then be installed using the traditional BIOS boot method. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |